Idiomas disponibles
Idiomas disponibles
Installation
General starting points
for installation
X Perform the following steps
before starting installation.
X Stop valves must already be
installed.
X Close the stop valves.
X In existing installations, remove
the tap, hoses and boiler if still in
place.
X Mark the existing cold and hot
water connection.
X If Chiller is to be used as part
of the system, there must be
wall plug socket available for
connection.
Important: For subsequent steps,
it will be required to cut and route
tubing to fit the specific application
in your home. All tubing must be cut
squarely and free of burrs. Ensure
there is no damage within 1" of the
cut end.
X Do not use any form of sealing
compounds, this is not required
for push fit connections, and
using sealing compounds could
cause leaks.
X All tubing connections must be
firmly seated.
X Tubing must be routed to
avoid sharp bends and have
enough slack to avoid straining
connections. A P-clip and
mounting screw is included
to hold the tubing in place as
needed.
X Pull gently on each connection
to make sure they are secure.
See images below for details on
tubing installation and removal.
How to insert/remove
tubing in push fit
connections
X Insert the tubing squarely (Fig. 1).
X Make sure to insert tubing
completely (Fig. 2).
X To remove, push in collet and pull
out tubing (Fig. 3).
17
EN
