Urmet MTV300E-UP Instrucciones página 10

Layouts
Configuration duration
Upon exiting the factory, timing is not active. 25 short presses
are required to set the duration in seconds (from 2 seconds
to 240 seconds). To return to a duration in minutes, 26 short
presses must be made.
Relay mode
It is possible to disable the dimmer's dimming functionality and
turn the product into an electronic step-by-step relay. Make 20
short presses (response: 10 flashes). Upon exiting the factory,
the product behaves as a dimmer.
Memory
The last brightness level set by means of a long press is stored
in memory to be recalled at the next switch-on with two short
presses (default setting).
Adjusting the minimum brightness level
Adjust the level to the desired minimum with a long press of the
button. Then make 27 short presses (response: 7 flashes). To
reset the minimum brightness level to the factory setting, make
28 short presses (response: 8 flashes)
Shutdown warning
Upon exiting the factory, the warning is switched off. To activate
the warning, push briefly for 24 times. In this way, 60 seconds
before the switch-on time expires, if it has been configured in
minutes, or 10 seconds, if it has been configured in seconds,
the light flashes briefly. If the button is pushed briefly for
another time, the light timing is reactivated.
Automatic network creation
NB: Connection to the receiver network can take between 5 and 20 seconds
10/28
Functioning
A short press switches the light on or off 100 per cent. A
double press sets the lighting to the stored intensity value. The
brightness change and its storage is achieved by a long press
on the button (with the light switched on). When released, the
achieved brightness level is stored. With each new press, the
direction of change is reversed.
100% brightness
A short press of the button increases the brightness to 100 per
cent (default setting).
100% mode or memory recall on short press
In certain applications, it is preferable to recall the memory
when first pressed. In this case, 2 short presses are required
to achieve 100 per cent illumination. Make 32 short presses to
switch this mode on or off.
Long ignition duration (12 hours)
6 short presses on the button give a momentary delay of 12
hours. This makes it possible not to switch off if the set duration
has been configured to shorter switch-on times.
Flashing mode
In this mode, if the MTV300E-UP receives a flash command
from the transmitter, it flashes. Pressing a button on the
transmitter restarts the flashing. To activate or deactivate it, make
22 short presses. This mode can be used to visually notify an
event (ringtone, etc.).