Idiomas disponibles
Idiomas disponibles
WARNING:
• Do not immerse the appliance in water. It could cause an elec-
tric shock or fire.
• The milk nozzle is hot immediately after use!
CAUTION:
• Do not use a wire brush or other abrasive objects.
• Do not use harsh or abrasive cleaning agents.
Clean the outside of the appliance with a slightly damp cloth
if necessary – without any additives.
Brew Head and Rubber Seal
Wipe the brew head and the rubber seal with a damp cloth.
Dampen a soft nylon brush beforehand to remove stubborn
dirt. Dry off with a dry cloth.
Milk Nozzle and Milk Tank
For reasons of hygiene, clean the milk nozzle, the milk tank
and its parts after each use as follows:
1. Remove the milk tank from the appliance. Remove the
cover from the milk tank.
2. Clean the milk tank in warm rinsing water with a little
hand washing-up liquid.
3. Fill the milk tank with approx. 250 ml of clean, fresh water
and reinsert the milk tank with the cover.
4. Fill the water tank with clean, fresh water up to the MAX
mark. Close the lid of the water tank.
5. Set the control on the top of the milk tank to position .
6. Swivel the milk nozzle outwards with the adjustment
lever on the milk tank.
7. Place a suitable container (heat-resistant / approx.
250 ml) under the brewing head. If necessary, change
the length of the milk nozzle as previously described.
8. To carry out the cleaning function, press and hold the
CLEAN / CAPPUCCINO button for 3 seconds. A beep
sounds and the four control lamps on the left flash alter-
nately in a circle.
WARNING: Risk of Burns!
• During this process, a lot of hot steam is generated
and the milk pipe is rinsed with hot water.
• The water in the container and the milk nozzle are
hot!
When the process is complete, all control lamps pulsate.
9. Remove the milk tank and remove the remaining water
from the milk tank.
20
PC-ES-KA1266_IM_01.2024
Thorough Cleaning
For thorough cleaning, the stainless steel attachment for
the milk nozzle and the connection plug from the milk tank
cover can be removed.
1. Wait until the stainless steel attachment for the milk
nozzle has cooled down.
2. Turn the attached stainless steel attachment for the milk
nozzle a short turn to the left.
3. Pull the stainless steel attachment downwards beyond
the last position.
4. Clean the stainless steel attachment in warm rinsing
water with a little washing-up liquid.
- If necessary, you can use a fine, soft nylon brush.
5. Rinse with clear water and place the stainless steel
attachment back on the milk nozzle. Secure it at the
desired height.
6. Turn the connection plug in the direction
out.
7. Clean the connection plug with tap water and dry it.
8. Insert the connection plug back into the opening and
secure it by turning it in the direction .
Accessories
The filter holder, filter inserts, drip grid, collection container,
water tank and measuring spoon can be cleaned in warm
water with a little washing-up liquid. If necessary, you can
use a fine, soft nylon brush. Rinse with clean water. Dry the
parts with a soft cloth.
CAUTION:
These parts are not suitable for cleaning in the dish-
washer. Exposure to heat and harsh cleaners could
cause them to warp or discolour.
Water Tank
1. Pull it out upwards with both hands. Reinsert it after
cleaning and drying.
2. Reinsert the water tank. Make sure that it is seated in the
holder on the appliance.
3. Press the water tank down slightly so that the valve
opens.
and pull it
03.01.24
