Idiomas disponibles
Idiomas disponibles
Assembly
1
Preparing the canopy
Remove the canopy bottom cover (C) from the canopy (B) by
turning the canopy bottom cover (C) counterclockwise.
Remove the mounting bracket (A) from the canopy (B) by
removing the non-slotted canopy mounting screw (FF) from
the bottom of the canopy (B) and loosening the slotted canopy
mounting screw (FF) a half turn from the screw head. Next,
turn the canopy (B) counterclockwise to remove the mounting
bracket (A) from the canopy (B).
FF
3
Assembling the fan
WARNING: Failure to properly install the cotter pin (GG) could
result in the fan loosening and possibly falling.
NOTE: If a longer downrod (not included) is needed, take out
the screw located in the hanger ball (KK), lower the hanger ball
(KK) and remove the cross pin (LL). Remove all three pieces
from the downrod and assemble them onto the new longer
downrod before proceeding to the downrod installation.
Carefully feed the motor wires and safety cable (MM) up
through the downrod (NN). Thread the downrod (NN) into the
collar.
Align the holes and replace the clevis pin (HH) and cotter
pin (GG). Tighten the two collar set screws (II).
Slip coupling cover (E), canopy bottom cover (C), and canopy
(B) onto the downrod (NN).
Carefully reinstall the hanger ball (KK) onto the downrod (NN).
Tighten the set screws (JJ) by using the hex wrench (DD)
provided.
2
Preparing the motor
Remove the cotter pin (GG) and clevis pin (HH), and loosen
the two collar set screws (II) from the motor collar.
Loosen two set screws (JJ) located in the hanger ball (KK)
by using the hex wrench (DD) provided. Lower the hanger
ball (KK) and remove the cross pin (LL). Remove the hanger
ball (KK) from the hanger ball/downrod assembly (D).
A
DD
FF
B
C
Make sure the cross pin (LL) is in the correct position, the
set screws (JJ) are tightened and wires are not twisted.
7
LL
JJ
D
GG
LL
JJ
DD
HH
Please contact 1-833-HDFANS-1 / (1-833-433-2671)
KK
JJ
HH
II
II
MM
KK
JJ
NN
B
C
E
GG
II
II
F
HOMEDEPOT.COM
for further assistance.
