Idiomas disponibles
Idiomas disponibles
EN
20
SAFETY INSTRUCTIONS
•
The supply socket must be earthed reliably. The rated current of the socket
shall not be lower than 16 A. The socket and plug shall be kept dry to prevent
electrical leakage.
•
The installation height of the supply socket shall not be lower than 1.8m .
•
The wall in which the electric water heater is installed shall be able to bear
the load more than two times of the heater fully filled with water without
distortion and cracks. Otherwise, other strengthening measures shall be
adopted.
•
The multifunction valve attached with the heater must be installed at the cold
water inlet of this heater.
•
When using the heater for the first time (or the first use after maintenance),
the heater cannot be switched on until it has been fully filled with water.
•
When filling the water, at least one of the outlet valves at the outlet of the
heater must be opened to exhaust the air. This valve can be closed after the
heater has been fully filled with water.
•
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities or lack of experience and
knowledge, unless they have been given training or instructions concerning
use of the appliance by a person responsible for their safety.
•
During heating, there may be drops of water dripping from the pressure
release hole of the multifunction valve. This is a normal phenomenon. If there
is a large amount of water leak, please contact customer service center for
repair. This pressure release hole shall, under no circumstances, be blocked;
otherwise, the heater may be damaged, even resulting in accidents.
•
The drainage pipe connected to the pressure release hole must be kept
sloping downwards.
•
Since the water temperature inside the heater can reach up to 75°C, the hot
water must not be exposed to human bodies when it is initially used. Adjust
the water temperature to a suitable temperature to avoid scalding.
•
If the flexible power supply cord is damaged, the special supply cord provided
by the manufacturer must be selected, and replaced by the professional
•
maintenance personnel.
•
If any parts and components of this electric water heater are damaged, please
contact customer service center for repair.
