Idiomas disponibles
Idiomas disponibles
5. Install the Hanger - Surface-Mount Installation
Wall Stud or Support
CAUTION: Risk of personal injury. This product is heavy. Get assistance lifting and moving the product.
NOTE: The following instructions are for surface-mount installation only. For recess-mount installation, refer to the
"Recess-Mount Installation" sections.
With help, lift and hold the cabinet in position on the wall.
Position the bottom hanger in place under the cabinet on the wall, centered with the centerline of the cabinet.
Verify that the cabinet and hanger are level.
With help, set the cabinet down onto a padded surface.
If the mounting-holes have not been marked, measure and mark the mounting-hole locations for the bottom hanger(s).
If there is a wall stud or support at the marked mounting-hole locations, drill 1/8" pilot holes at the marked mounting-
hole locations.
For drywall, drill 1/8" pilot holes at the marked mounting-hole locations.
For concrete walls, drill 1/4" pilot holes at the marked mounting-hole locations.
For drywall without a stud, install the anchors (not provided).
For concrete walls, install the anchors (not provided).
Secure the hanger with the provided ST3.9x50 screws.
1558797-2-B
Drywall or Concrete
10
Hanger
Kohler Co.
