ENGLISH
of the body.
Keep the drain cap and the water plug properly.
During drainage, the body can be tilted slightly backwards.
If the water container cannot hold all the water, before the water container is full, stuff
the water outlet with the water plug as soon as possible to prevent water from flowing
to the floor or the carpet.
When the water is discharged, re-tighten the water plug and tighten the drain cap.
Restart the appliance after the plug and cap are installed, otherwise condensed water
of the appliance will flow to the floor or the carpet.
Continuous drainage. Fig. 11
1. Unscrew the drain cap and unplug the water plug.
2. Set the drainage pipe into the water outlet.
3. Connect the drainage hose to a bucket or big container.
Protection features:
Frost protection function
In cooling and dehumidification modes, if the temperature of the evaporator outlet
pipe is too low, the appliance will automatically enter protection mode to prevent
damage to the evaporator. The appliance will restart when the temperature is
restored to normal values.
Condensate water flooding protection function
When the water level exceeds the maximum level allowed by the safety buoy, the
appliance will switch off and activate the FULL indicator on the control panel. To
restart the device, the water inside the device will need to be drained through the
bottom drain plug (shown in detail in the drainage instructions section). Once the
water has been drained, the device will restart.
Automatic defrost
This air conditioner has an automatic defrost function.
Compressor protection function
To increase the service life of the compressor, it has a 3-minute delay booting
43
EVVO VENTILADOR PORTÁTIL CLIMA P9 FRÍO Y CALOR
