Maintenance; Led Indicator Lights; Removing The Cleaner From The Pool - Pentair PROWLER 930 Guia De Instalacion

8
Make sure the cleaner' s power supply is turned "OFF" and is disconnected from the electrical
source/outlet before servicing the cleaner. Moving parts may injure hands or fingers if cleaner
inadvertently powers on during servicing.

LED Indicator Lights

The Prowler™ 930 Robotic Pool Cleaner includes an
LED indicator just above the scrubber on the front side
of the cleaner. See Figure 16. During normal operation
powered by the power supply the LED indicator will blink
blue.

Removing the Cleaner from the Pool

The cleaner will shut off automatically at the end of a
cleaning cycle. Follow the STEPs below to remove the
cleaner from the pool.
Ensure the power supply is turned "OFF"
and disconnected from the electrical
source/outlet before removing the cleaner from the
pool. Operating the cleaner out of water will immediately
cause severe damage and will result in loss of warranty.
Do not leave the cleaner in the pool all the time.
1. Disconnect the power supply cable from the
electrical outlet and disconnect the cleaner
communication cable from the power supply.
2. Using the communication cable, slowly and gently
pull the cleaner to the waterline at the edge of the
pool until you can reach the handle. DO NOT lift the
cleaner out of the water by the cable.
3. Using the handle, lift the cleaner out of the pool.
See Figure 17.
Note: Never lift the cleaner out of the pool by the
communication cable. This puts an unnecessary
strain on the cable and could result in damage to
the cleaner.
4. Place the cleaner on the edge of the pool and allow
excess water to drain from the cleaner body and
basket. See Figure 18.
5. Disconnect the communication cable from the
power supply.
6. Store the cleaner in a covered area with the
communication cable coiled.
PROWLER™ 930 Robotic Inground Pool Cleaner Installation and User' s Guide

MAINTENANCE

Figure 16
Figure 17
Figure 18