Idiomas disponibles
Idiomas disponibles
Installation instructions
and use of the energiser
AKO Sun Power S250
1. Description of elements
1
4
3
2
2. Charging the 12-volt battery
To optimise the life of the battery, it is essential to charge it for the first time using the charger supplied. The 12-volt battery is located at
the rear of the energiser. To remove it, unscrew the screw from the protective cover, remove the protective cover and take out the
battery:
Loading instructions
Before using and operating the Sun Power S250 energiser, we recommend that you charge the 12-volt
battery for at least 12 hours without interruption. This will maximise the life of the battery. Only use the
original charger to charge the 12-volt battery, otherwise irreversible damage may occur. This charger is
only compatible with the 12 volt battery supplied with the Sun Power S250, do not use this charger for
other batteries. To charge the battery, please follow the steps below:
9
5 7
8
6
Kerbl France - www.kerbl.fr
1 - 12-volt battery
2 - 12-volt battery charger
3 - Traffic sign
4 - Fixing screw for wooden post
5 - Fence connection cable
6 - Earth connection cable
7 - Screw for earth connection cable / earth spike
8 - Earth stake
9 - Sun Power S250 energiser
To charge the battery, disconnect the white PVC
terminals from the "+" (red) and "-" (black) terminals. We
advise you to keep these PVC terminals for storing the
battery when not in use (see point 3. Important
information about the 12-volt battery).
Then connect the charger's connection clamps,
observing the correct polarity: the black clamp to the "-"
(black) terminal and the red clamp to the "+" (red)
terminal, then connect the charger to a 220-volt
electrical socket.
EN
10
