3.5 Engineering Menu
3.5.1 Parameter settings of the wired controller
● Parameters can be set in the power-on or power-off state.
● Hold "
" and "
interface.
● After entering the parameter setting interface, Press "
to switch the parameter. Set parameters according to the Table of
Parameter Settings. Press "
interface. Then press "
and press "
● Press the "
the parameter setting or exiting the parameter setting after 60s
without any operation.
● When it is in the parameter settings page, the wired controller
does not respond to any remote control signal.
" for 3 seconds to enter the parameter setting
" and "
" to save changes.
" button to return to the previous page until exiting
" to enter the parameter setting
" to change parameter value
67
" and "
"
V.1
