Idiomas disponibles
Idiomas disponibles
Dry Filter & Waste Separator
Brush Roller Self-cleaning
Brush Roller Cover
②
①
Squeeze latches on the cover and pull upward
to remove.
Grasp recessed area on each side of the dry filter and pull
upward. Rinse under running water and must be completely
dry before recombining with the lid of the DWT.
* A spare dry filter is provided with your appliance for
convenient replacement.
The waste separator can be removed and rinsed under the
running water.
* The function of the waste separator is to separate solid
waste.
* The appliance can function normally without the waste
separator, so users can decide whether to keep it or not.
1. Place the appliance on the charging dock after use, the
sensor will auto-detect the level of dirt.
2. When you hear the voice prompt "please start self
cleaning", press the self-cleaning button and begin the
process.
3. Once complete, you will hear the voice prompt "self
cleaning completed, please clean the Dirty Water Tank."
At this point, the appliance will begin charging.
Note:
• Ensure the charging dock is plugged in and the battery
level>30%.
• Before self-cleaning cycle, please clean the DWT and
ensure the water level in the CWT>30%.
• During the drying process, if you press the self-cleaning
button, the drying process will be interrupted. You can
press it again to restart self cleaning.
Wipe with a wet cloth.
While replacing, always latch the brush cover
into place to avoid leakage.
54
