Removing The Doors; Adequate Ventilation - essentiel b ERAVDE180-90v1 Instrucciones De Uso

Climate classes
The appliance must be installed in a location with an ambient temperature that is compatible
with the climate class for which it was designed (see table below).
The table below sets out which ambient temperatures are compatible with which climatic
classes:
Climate classes
SN
N
ST
T
Please refer to the data plate or product datasheet to find your appliance's climate class.

Adequate ventilation

• Make sure that air can circulate freely around the appliance.
• To ensure that your appliance works properly, do not obstruct the air vents and leave
a gap of at least 100 mm above the appliance, 50 mm between the back and the wall
and 100 mm on either side. Please observe the installation dimensions indicated in the
diagram below.
• If you are going to install your appliance next to another refrigerator or freezer, make sure
they are not stuck together as this could cause condensation on the outside.
32
V.1.0
installation
Ambient temperature
+10 to +32°C
+16 to +32°C
+16 to +38°C
+16 to +43°C
A 1524 mm
B 1062 mm
C 160°
E 50 mm
F 100 mm

Removing the doors

If the refrigerator does not pass easily through a doorway, you can remove the doors of the
appliance.
• FREEZER DOOR
1. Close the freezer compartment door and remove the top hinge A, then carefully
disconnect the electrical wires.
2. Remove the hinge B screw by turning it anticlockwise then remove the hinge. Be careful
not to drop the door.
3. Lift the door vertically and remove it from the lower hinge C.
• REFRIGERATOR DOOR
• Remove the refrigerator compartment door in the same manner as for the freezer door
(steps 1 to 3 above).
When removing the doors, please make sure to lift them vertically to avoid damaging
the hinges. Be careful not to crush the electrical wires in the doors. Place the doors
on a padded surface to avoid scratching them.
• You can then reinstall the refrigerator and freezer compartment doors by following the
disassembly instructions above in reverse order.
Levelling the feet
The appliance must be made level to prevent vibration in use. To
level the appliance, adjust the front feet.
33
V.1.0
installation