Tabla de contenido
Idiomas disponibles
Idiomas disponibles
)
1 (continued)
Slide tight
tight
to Side
Jamb.
2
nd
4
th
Position Sill Adaptor on patio door sill and slide tight to side jamb. Mark hole
locations, drill 1/8" holes through the first sill wall ONLY, clear debris, reposition Sill Adaptor,
apply sealant in holes, and fasten with #8 x 3/4" Stainless Steel Thread-Forming Screws. DO NOT overtighten screws.
9 2 0 5707
·
Verify Patio Door is plumb, level,
and square. Correct as needed until
measurements are within 1/8".
NOTICE
·
Protect surfaces
from tool contact.
Failure to do so
could result in
surface marring or
product damage.
Sill
Adaptor
·
component part, typically about
1/8". Failure to do so could result
in product or property damage.
Mark hole locations on
gliding patio door sill then
remove Sill Adaptor.
·
screws. Doing so could
Reposition Sill
result in product damage.
Adaptor.
IMPORTANT
1
st
NOTICE
Only drill through first wall of
3
rd
NOTICE
DO NOT overtighten
5
th
8
A-Series
A-Series
#8 x 3/4"
Stainless
Steel Thread-Forming Screw
Position Sill Adaptor
on gliding patio
door sill.
Drill 1/8" holes
through gliding
patio door sill
at marked hole
locations (first
wall ONLY).
Apply sealant in
holes and fasten
Sill Adaptor
with #8 x 3/4"
Stainless Steel
Thread-Forming
Screws.
Tabla de contenido
