Tabla de contenido
Idiomas disponibles
Idiomas disponibles
)
1
Slide tight
tight
to Side
Jamb.
2
nd
4
th
Position Sill Adaptor on patio door sill and slide tight to side jamb. Mark hole
locations, drill 1/8" holes through the first sill wall ONLY, clear debris, reposition Sill Adaptor,
apply sealant in holes, and fasten with #8 x 3/8" Stainless Steel Thread-Forming Screws. DO NOT overtighten screws.
9 2 0 5707
·
Verify Patio Door is plumb, level,
and square. Correct as needed until
measurements are within 1/8".
·
Protect surfaces from tool contact. Failure to do so
could result in surface marring or product damage.
Sill
Adaptor
NOTICE
·
Only drill through first wall of component
part, typically about 1/8". Failure to do so
could result in product or property damage.
Mark hole locations
on gliding patio
door sill then
remove Sill
Adaptor.
·
DO NOT overtighten
Reposition Sill
screws. Doing so could
Adaptor.
result in product damage.
IMPORTANT
NOTICE
1
st
3
rd
NOTICE
5
th
7
200/400 Series
#8 x 3/8"
Stainless
Steel Thread-Forming Screw
Position Sill Adaptor
on gliding patio
door sill.
Drill 1/8" holes through
gliding patio door sill at
marked hole locations
(first wall ONLY).
Apply sealant in holes and
fasten Sill Adaptor
with #8 x 3/8"
Stainless Steel
Thread-Forming
Screws.
Tabla de contenido
