(continued)
3
Slide Head Track
Retainer tight
tight
to Side
Jamb.
Drill 1/8" holes
at marked hole locations
in head jamb groove.
NOTICE
·
Only drill through first wall of component
part, typically about 1/8". Failure to do so
could result in product or property damage.
5
Remove and
Drill 1/8" holes
at marked hole
locations.
Fully open patio door. Measure and mark hole locations 2" from opening ends in head jamb and the midpoint between
marks. Remove and drill 1/8" holes at marked hole locations. Position Head Track Retainer in existing screen track, tight
to side jamb. Mark hole locations using predrilled holes as a guide. Remove and drill 1/8" holes at marked hole locations,
clear debris, and fasten with #8 x 3/8" Self-Drilling Screws.
9 2 0 5707
Mark hole
locations on
interior face of
head jamb track
groove.
NOTICE
·
Protect surfaces from tool contact.
Failure to do so could result in
surface marring or product damage.
2
nd
Position Head
Track Retainer
in head jamb
Existing Screen
Track.
th
Reposition
Head Track
Retainer.
Existing
Screen Track
Interior
1
View
Mark 2" from
opening
ends and
the midpoint
between marks.
3
rd
6
th
13
E-Series
E-Series
#8 x 3/8"
st
Self-Drilling
Screw
Groove
Midpoint
2"
Interior View
Existing
Screen
Track
Mark hole
locations on
Head Track
Retainer.
Fasten Head
Track Retainer
with #8 x 3/8"
Self-Drilling Screws.
2"
4
th
7
th