Idiomas disponibles
Idiomas disponibles
3.2.
Preparing for use
APPLIANCE LOCATION
The temperature of environment must not be higher than 40°C and the relative humidity should be less
than 85%. Ensure good ventilation in the room in which the device is being used. There should be at least
10 cm distance between each side of the device and the wall or other objects. The device should always be
used when positioned on an even, stable, clean, fireproof and dry surface, and be out of the reach of
children and persons with limited mental and sensory functions. Position the device such that you always
have access to the power plug. The power cord connected to the appliance must be properly grounded
and correspond to the technical details on the product label.
Disassemble the device and all its components and clean them before the first use.
3.3.
Device use
Connect the power, turn on the power switch and set the required temperature.
When the temperature reaches the set degree, open the door and insert the pizza into the compartment.
When the pizza is baked, switch off the power, open the door, remove the pizza outside.
When finished, switch off the appliance and disconnect the power.
Setting the temperature value:
Press buttons (4) / (5) to set the temperature value (a long press will rapidly increase/decrease the value).
When the button is released, the temperature will be set.
Memory selection:
Press the memory selection button (3) and P[X] will appear, where X stands for 1-6.
The temperature value will automatically be stored when the unit is started with the set temperature, and
when P[X] is selected again using the button (3), the previously set temperature will automatically be
displayed.
3.4.
Cleaning and maintenance
a)
Unplug the mains plug and allow the device to cool completely before each cleaning, adjustment or
replacement of accessories, or if the device is not being used.
b)
Use only non-corrosive cleaners to clean the surface.
c)
Use only mild, food-safe detergents to wash the device.
d)
After cleaning the device, all parts should be dried completely before using it again.
e)
Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
f)
Do not spray the device with a water jet or submerge it in water.
g)
Do not allow water to get inside the device through vents in the housing of the device.
h)
Clean the vents with a brush and compressed air.
i)
The device must be regularly inspected to check its technical efficiency and spot any damage.
j)
Use a soft, damp cloth for cleaning.
k)
Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or a metal spatula) because they
may damage the surface material of the appliance.
l)
Do not clean the device with an acidic substance, agents of medical purposes, thinners, fuel, oils or
other chemical substances because it may damage the device.
DISPOSING OF USED DEVICES:
Do not dispose of this device in municipal waste systems. Hand it over to an electric and electrical device
recycling and collection point. Check the symbol on the product, instruction manual and packaging. The
plastics used to construct the device can be recycled in accordance with their markings. By choosing to
recycle you are making a significant contribution to the protection of our environment.
Contact local authorities for information on your local recycling facility.
EN
