Safety Warnings - Wolder AUTOBIKE TECH X1 Manual De Instrucciones

SAFETY WARNINGS

• This bike carrier has been designed, built and factory tested with care, in compliance with the safety standards.
• Watch out for passing through underground passages, tunnels, car-parks, garages and the like.
• After traveling a short distance, check the assembly to make sure it is fixed properly. Check the straps and the
vanous bolts to make sure they are well tightened, and subsequently check regularly during the trip.
• Straps and screws will get worm with time. In this case, they must be replaced immediately.
• In consequence of the presence of carrying and load device, comply the speed with the different way of driving
and braking.
• Vehicle driving will be influenced by the effect of wind, sudden braking, tight bends, high speed rises and dips
on uneven roads. Therefore, reduce the speed, comply with local speed limits and, in any case, never exceed
130kph.
• The manufacturer shall not be liable for damage deriving from high vehicle speed or improper driving.
• Before starting, each time and frequently during the joumey, check to make sure that the fixing mechanisms and
bolts are tightened properly, and that the assembly is in good condition.
• The bikes must have no exposed sharp edges that could cause injuries to persons.
•
Dismantle the bike rack if it is not being used.
•
Dismantle the bike rack when the vehicle is washed.
•
Do not cover the bikes with objects that can be removed by the wind-force.
•
This rack requires accurate assembly and strict observance of the installation and use instructions. When driving
your vehicle, you are entirely responsible for your own safety and that of others.
• Respect the laws applicable in the country of use.
• Make these instructions available to anyone else using your bike rack.