Idiomas disponibles
Idiomas disponibles
while it is running. Unplug after each use. Unplug the unit
by pulling the plug and not the power cord.
Do not immerse product in water or other liquids and
avoid splashing liquids reach the unit.
Before carrying out any cleaning, disconnect the unit
from the electrical outlet.
Before each use, unroll the power cord. Do not insert
anything through the protection grids.
Do not obstruct in any way the protection grids.
Place on solid and stable surfaces and away from
windows or drafts.
1 Front protection grid
4 Rear fan stopper
7 Oscillation pin
10 Control panel
12 Motor protection
ASSEMBLING
The fan motor can work even if the protective grids have not yet been assembled and fixed. To ensure the
maximum safety, perform the installation completely before operating.
1) Insert the power cord in the hole of the detachable base.
2) Insert the lower part of the housing in the hole of the base (1). Rotate clockwise until lock.
3) Place the rear grid (5) near the plastic motor protection (12) with the metal handle facing upwards. Fit the
holes present in the central part of the grid with the pins in the plastic protection (12) and lock the two parts
with the stopper (4). Insert the fan (3) into the shaft (6) and screw the cover of the fan (2) to the threaded
end of the drive shaft. Remove the fixing screw (13).
4) Place the front grid (1) in front of the rear grid (5) matching the holes on the grids.
5) Close the locking pins and fasten the two grids tightening the securing screw (13) previously removed.
OPERATING
Once finished assembling the unit, place the fan following the safety instructions, then plug it to the electrical
outlet. By using the control panel (10) the rotation power can be adjusted on different speeds.
0: fan is OFF
OSCILLATION
The oscillation of the head is only possible when the fan is turned on and it can be activated by pressing the
pin (7) downwards until it locks. Lifting the pin (7) until the locking function is disabled. It is recommended
to enable or disable oscillation of the fan only when the unit is off.
CLEANING
Disconnect the plug from the electrical outlet before attempting any cleaning operation.
Do not immerse the unit in water. In any case prevent splashes of water or other liquids reaching the motor
body. Do not clean the unit with metallic sponges or abrasive cleaners, only use neutral detergents and a soft
cloth moistened with water to clean the outer parts. Dry the product completely before operating the unit.
DESCRIPTION G50044
2 Fan stopper
5 Rear protection grid
8 Main body
11 Detachable base
13 Front grid fixing screw
1: low speed
2: medium speed
3 Fan
6 Drive shaft
9 Inclination pin
3: high speed
9
