Adjust the light intensity by selecting any of the Light Level buttons as needed.
Example: Warm light level 3 is selected.
Troubleshooting
Problem
Excessive vibration.
Both the light and
Suction performance
reduced.
All lights for the fan
three seconds before
the hood reverts to
Manual Mode.
All lights for the fan
from left to right for
the hood reverts to
Manual Mode.
This appliance respects laws of the suppression of radio interference. As the Manufacturer has a policy of
necessary without prior warning.
5059340445915_MNL_IN_V02.indb 71
Possible cause
The appliance is not installed
The fan blade is damaged.
tightly.
The fan blade is jammed.
The motor is damaged.
Light bulb blown.
Power connection loose.
Speed may be too low.
Top vent might be obstructed.
twisted.
The installation may not
comply with the manufacturers
instructions.
Calibration error.
Sensor error.
Solution
Switch off the appliance. Repair to be carried
Ring the customer helpline at the end of the
Care & maintenance section to arrange an
engineer visit.
Select a higher speed.
Clear any obstruction.
manufacturer's instructions.
The vent hose should be correct diameter
throughout with no reductions or restriction.
(See installation section).
Control panel and set up). If this does not
the end of the Care and maintenance section.
Note: The hood will still operate in manual
mode.
Turn off the power supply at the consumer
unit. Wait for two minutes and turn the power
(see Control panel and set up). If this does not
the end of the Care and maintenance section.
Note: The hood will still operate in manual
mode.
71
02-09-2022 11:26:51
