Idiomas disponibles
Idiomas disponibles
•
Use the appliance for its intended purposes only, as indicated in this instruction manual.
3. PARTS IDENTIFICATION
Check that all the elements shown in the figure are present in the package: if there are any missing or
damaged parts, do not proceed with the assembly and commissioning in any way and contact the dealer to
have the equipment restored.
4. ASSEMBLY
A) Turn the base upside down and place the counterweight in the center, oriented as in the figure.
B) Insert the thread of the fixed stem into the hole in the center of the basement.
C) Screw the basement nut onto the stem thread clockwise until fully tightened.
D) Turn the base upside down and place it on the ground on a horizontal and stable surface.
E) Turn the stem ring counterclockwise and pull the extractable stem completely out.
F) Fix the extractable stem by turning the ring clockwise.
G) Fully insert the motor unit (7 + 8 + 9 + 10) into the extractable stem as in the figure, matching the
screw with the special recess provided in the extractable stem; it may be helpful to slightly unscrew
the fixing of the stem (10), trying not to extract it completely so as not to let the internal nut come
out. In this case, refit the nut and partially tighten the fixing.
H) Rest the rear grid on the motor, orienting the handle upwards, so as to match the pins of the motor
plate with the central holes at the top of the center of the grid.
I)
Screw the grid nut onto the motor thread by turning it clockwise until it is fully tightened.
J) Insert the propeller on the motor shaft, taking care to match the cross pin of the shaft with the
groove on the rear part of the propeller.
K) Screw the propeller nut firmly onto the motor shaft by turning it counterclockwise.
1
Front shield
2
Front grid
3
Propeller nut
4
Propeller
5
Grid nut
6
Rear grid
7
Swing command
8
Motor
9
Command group
10
Stem fixing
11
Extractable stem
12
Stem Ring
13
Fixed stem
14
Basement
15
Counterweight
16
Basement nut
