Idiomas disponibles
Idiomas disponibles
FMFP12758_9R202313RA_FM_2N1 FLOORING TOOL_MAN_CC:FMFP12758_9R202313RA_FM_2N1 FLOORING TOOL_MAN_
LOADING THE FMFP12758
EYE PROTECTION which conforms to ANSI specifications and provides protection against
flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator
and others in the work area when connecting to air supply, loading, operating or servicing
this tool. Eye protection is required to guard against flying fasteners and debris, which
could cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye protection
equipment must conform to the requirements of the American National Standards Institute,
ANSI CAN/CSA Z89.1 and provide both frontal and side protection. NOTE: Non-side shielded
spectacles and face shields alone do not provide adequate protection.
TO PREVENT ACCIDENTAL INJURIES:
• Never place a hand or any other part of the body in nail discharge area of tool while the air supply
is connected.
• Never point the tool at anyone else.
• Never engage in horseplay.
• Never actuate the tool unless nose is directed at the work.
• Always handle the tool with care.
• Do not actuate the tool while loading.
FMFP12758
LOADING:
Retract pusher until it is in the locked position. Insert a stick of cleats or staples. Push the detent to unlock
the pusher. Slide pusher to the fully forward position. The tool is now ready to operate.
NOTE: Use only nails recommended for use in the FMFP12758 nailers or nails which meet the
STANLEY specifications.
BEFORE HANDLING OR OPERATING THIS TOOL:
I.
II. REFER TO "TOOL SPECIFICATIONS" IN THIS MANUAL TO IDENTIFY THE
READ AND UNDERSTAND THE WARNINGS CONTAINED IN THIS MANUAL.
OPERATING SYSTEM ON YOUR TOOL.
-6-
