Hansgrohe Tecturis E 240 Fine CoolStart 73072 1 Serie Instrucciones De Montaje / Manejo / Garantía página 2

Safety Notes
W A R N I N G : To avoid the risk of
product failure, property dam-
age, and personal injury, do the
following:
This product should be installed by a licensed
professional plumber.
This product is for use with drinking water only.
Install this faucet in an accessible area. Keep away
from external heat sources. The hoses should not be
allowed to rub against other items under the sink, such
as a trash bin.
The hot and cold supply hoses are for use with ⅜
stops. If your stops are a different size, install new
ones. Using anything other than ⅜ stops may result in
product failure and property damage.
The hoses on this faucet must not come into contact
with detergents or other materials containing chlorine
bleach, lye, hydrochloric acid, formic acid, acetic
acid, or other harsh chemicals as they can damage
the hose. Do not store such materials under the sink
where this faucet is installed.
Inspect the hoses for leaks or corrosion immediately
after installation and every six months thereafter.
Replace the hose if signs of leaks or corrosion are
detected.
Refer to the Cleaning Recommendations on page
11 when selecting a cleaning agent for this
product. Do not use cleaning products containing
chlorine bleach, lye, hydrochloric acid, formic acid,
acetic acid, or abrasives.
Failure to follow these instructions may
result in product failure and property
damage, and may void the warranty.
2
English
Installation Considerations
• Read over these instructions thoroughly before
beginning installation. Make sure that you have all
tools and supplies needed to complete the installation.
• This faucet does not include a drain or a pull rod.
• Keep this booklet and the receipt (or other proof of
date and place of purchase) for this product in a safe
place. The receipt is required should it be necessary to
request warranty parts.
Technical Information
Water pressure
Recommended
Maximum
Hot water temp.
Recommended
Maximum
Max. flow rate
Hole size in mounting surface
Max. depth of mounting surface
* Please know and follow all applicable local plumbing codes
when setting the temperature on the water heater.
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
120°-140° F (48° - 60° C)*
158°F (70° C)*
1.2 GPM (4.5 L/min)
1⅜" (34 mm)
1⅝" (40 mm)