Idiomas disponibles
Idiomas disponibles
Anleitung_HES_105_OG_SPK7:_
Important!
When using the equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating instructions and
safety regulations with due care. Keep this manual in
a safe place so that the information is available at all
times. If you give the equipment to any other person,
hand over these operating instructions and safety
regulations as well. We cannot accept any liability for
damage or accidents which arise due to a failure to
follow these instructions and the safety instructions.
1. Safety regulations
Please refer to the booklet included in delivery for the
safety instructions.
2. Layout and items supplied (Fig. 1-8)
1. Carrying strap
2. Thermostat control lamp
3. Housing cover
4. ON/OFF switch
5. Welding wire speed controller
6. Switch for welding current adjustment
7. Mains plug
8. Earth terminal
9. Hose package
10. Welding nozzle
11. Burner
12. Fastening screw for housing cover
13. Welding screen
14. Burner switch
2.1 Assembly material
k. 1 x Safety glass frame
l.
1 x Welding glass
m. 1 x Transparent safety glass
n. 2 x Safety glass retaining bushes
o. 3 x Nut for handle
p. 3 x Screws for handle
q. 2 x Safety glass retaining pin
r.
1 x Handle
s. 1 x Welding screen frame
3. Intended use
The flux cored welding set is designed for self-
shielding flux cored welding using suitable wire. The
additional application of gas is not required.
25.01.2011
8:21 Uhr
Seite 15
The equipment is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
equipment is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Technical data
Mains connection:
Welding current:
Duty cycle X%
Welding current I 2 (A):
Idling voltage:
Max. welding wire drum:
Welding wire diameter
Fuse:
Weight:
5. Before starting the equipment
5.1 Assembly (Fig. 7-13)
5.1.1 Fitting the carrying strap (1)
Guide the carrying strap (1) through the slit on
the rear of the equipment, over the housing
cover (3) and through the slit on the front of
equipment. Connect the ends of the carrying
strap as shown in Figure 5 and adjust the strap
to the required length.
Fitting the welding screen (13)
Place the welding glass (l) and the transparent
safety glass (m) over it in the frame for the safety
glass (k) (Fig. 7).
Press the safety glass retaining pins (q) into the
holes in welding screen frame (s) from the
outside. (Fig. 8).
Place the frame for the safety glass (k) with the
welding glass (l) and transparent safety glass (m)
from the inside into the recess in the welding
frame (s), press the safety glass retaining
bushes (n) on to the safety glass retaining pins
(q) until they engage to secure the frame for the
safety glass (k). The transparent safety glass (m)
GB
230 V ~ 50 Hz
45-90 A
10 60
90 45
31 V
0.4 kg
0.9 mm
16 A
14 kg
15
