Idiomas disponibles
Idiomas disponibles
EN
5.1 CONTROL PANEL
(Fig. 9)
4) Water quantity adjustment tap
Turn the tap (4) counter-clockwise to
increase the quantity of water or turn it
clockwise to decrease it.
20) Brush rotation start lever
With the machine powered, lever (20)
starts brush rotation and water dispens-
ing.
34) Main switch
Pressed on position "I" it lights up and
gives power to the machine.
Pressed on "0" it stops.
35) Suction unit activation switch
The operation of the switch is activated
by the key (36) in position "1" and switch
(34) in position "I".
With the switch in its "I" position, press
it down. The switch will light up and the
suction unit will activate.
36) Starter key
Turn the key to its "1" position to enable
the machine for function.
The key is activated by the switch (34) on
"I".
37) Operating hour indicator
Indicates the machine operating hours.
38) Brush rotation enabling switch
This switch can be enabled by turning the
key (36) to its "1" position.
Pressing the switch (38) enables brush
rotation; its operation is controlled by the
lever (20); the button lights up when the
brushes rotate.
39) Water solenoid valve switch
This switch can be enabled by turning the
key (36) to its "1" position and the switch
(38) to its "I" position.
Pressing the switch (39) opens the water
solenoid valve, its operation is controlled
by the lever (20); the button lights up
FRECCIA30 E 45_27lingue_2ed_09-2013.indd 6
when the solenoid valve is open.
Use the tap (4) to adjust the quantity of
water.
6.1 FILLING THE TANK
(Fig. 7
WARNING:
Only add clean mains water to the tank at
a temperature no greater than 50°C.
-
Remove the hose (26) supplied, connect
one end (26a) to a tap and insert the oth-
er end (26b) in the tank (5).
-
Check that the tap (40) is open.
-
Turn on the tap and fill the tank (5).
-
The level of water contained in the tank is
displayed on the transparent tube (15).
-
Pour the detergent fluid in the tank.
N.B.:
Use non-foamy detergents only. For the
quantities, follow the instructions provided by
the detergent manufacturer according to the
type of dirt.
DANGER:
If the detergent comes in contact with the
eyes and/or skin or if swallowed, refer to
the use and safety information booklet
provided by the manufacturer of the de-
tergent.
7.1 OPERATION (Fig. 8)
7.1.a - Checks before use
-
Check that the exhaust tube (12) of the
recovery tank is properly coupled and
properly sealed.
-
Check that the connector (41) on the
squeegee (11) is not blocked and that the
hose is connected correctly.
-
Check that the clean water exhaust tube
(15) is correctly coupled to the supports
and that the tap (40) is open.
EN-6
)
30/09/13 14:36
