Upper (Needle) Threading - Brother PX100 Manual De Instrucciones

A
2
3
4
C
D
5
E
2
4
3
1
B
5
6
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○

Upper (Needle) Threading

Turn power switch to "O".
1. Raise the presser foot lever and turn the balance wheel toward you
(counterclockwise) to raise the thread take-up lever to its highest
position.
2. Pull up the spool pin and place a spool of thread on it.
3. Pass the thread through guides. (See fig. A.)
1 Spool pin
2 Thread guide
3 Tension discs
4 Thread take-up lever
4. While holding the thread as shown in fig. B, C, pull it between the
tension discs.
5. Guide the thread to the back of the thread take-up lever and around
to the left (fig. D). Bring the thread through the slit by pulling it
toward you and into the eyelet.
5 Thread take-up lever
6. Bring the thread down and pass it behind the thread guide.
6 Thread guide
7. Thread the needle from front to back and pull out about 5 cm (2")
of thread as shown in fig. E.
NOTE:
Incorrectly feeding the thread may cause it to break, skip stitches or
wrinkle the fabric.
1
26