Idiomas disponibles
Idiomas disponibles
3. IMPORTANT INFORMATION
3.1 Important Information
In order to get the full screen brightness and easy visability of all numbers and symbols,
●
we recommend you use the included mains adaptor rather than batteries for the main
unit.
The remote sensor will work better if the main unit is powered by the included mains
●
adaptor rather than batteries.
Regarding the wireless remote sensor (which can be positioned indoors or outdoors),
●
if it is used outside particulatly in cold conditions we recommend the use of Lithium AA
(requires 2) batteries as this will result in a more powerful signal and ensure no signal
loss. This is only precautionary advice and the remote sensor does work fine with normal
Alkaline batteries.
●
The weather station needs to be powered for 12 hours before an accurate predition will
display.
3.2 Initial Operation
●
Open the Weather Station Battery compartment.
●
Insert 2 x AA batteries observing the correct polarity (+ and - marks) or connect the
mains power. Close the battery compartment.
●
When the power is connected all the icons on the LCD display will light up for 3 seconds,
you will hear a beep tone and the weather station will start to detect the indoor
temperature and humidity.
●
Next the Weather Station will attempt to connect with the outdoor sensor. This lasts
approximately 3 minutes and is displayed by the RF icon
●
Remove the battery compartment on the Wireless Outdoor Sensor, insert 2 x
AAA batteries observing the correct polarity (+ and - marks) and close the battery
compartment.
●
Once the weather station has created a connetion to the outdoor sensor the clock will
start automatically searching for the WWVB Signal to set the time and date.
●
If Weather Station failed to receive transmission from outdoor sensor ("- -" is displayed
on the LCD), press and hold - button for 3 seconds to receive transmission manually.
The RF icon
connected.
3.3 Backlight
When using battery power the backlight will be off. Press the SNOOZE/LIGHT button to
●
enable the backlight for 15 seconds.
When using Mains power the backlight will be lit automatically. Press the SNOOZE/
●
LIGHT button to adjust the backlight. The backlight has three settings on mains power
High Brightness / Low Brightness / No Backlight.
will flash on the LCD and the outdoor temperature will show when it is
flashing.
5
