Idiomas disponibles
Idiomas disponibles
How to disassemble the oven door
For a thorough cleaning, you can remove the oven door. Proceed as follows:
-
Open the door fully (Fig. 5).
-
Fully open the left and right hinge levers (Fig. 6).
-
Hold the door as shown in figure 7.
-
Gently close the door until the left and right hinge levers are engaged in part B of the door
(Fig. 8).
-
Remove the hinge hooks from their location following the arrow.
-
Rest the door on a soft surface.
-
To replace the door, repeat the above steps in reverse order.
Removing the inner glass
-
Double oven door: Remove the seal by unscrewing the screws (Fig. 9).
-
Carefully remove the inner glass (Fig. 10).
-
Clean the glass with a suitable cleaner. Dry it thoroughly and place it on a soft surface.
-
Then you can also clean the inside of the outer glass.
Steam cleaning
-
This function helps to remove food residues from inside the oven. This method is only
effective for the removal of light, non-fouling dirt. It is not effective to remove stubborn
stains caused by cooking. This function can only be used when the oven is cold.
-
Cleaning procedure:
1.
Remove all shelves, plates, racks, trays, etc.
2. Prepare a solution of water (85%), white vinegar (10%) and dish detergent (5%) and spray
generously on the door, side walls and rear wall of the oven cavity (Fig. 11).
3. Pour 40 ml of water into the base of the oven cavity (Fig. 4).
4. Close the door. Set the Steam-Assisted Cleaning function and the temperature to 130 °C.
5. Turn off the oven after 18 minutes.
6. Allow to cool to a safe level before wiping the inside surface with a damp cloth.
7.
Dry the entire interior properly with a cloth or absorbent paper.
WARNING: make sure the oven is completely cooled down. Danger of burns.
Note
-
Slight differences in colour in the front part of the device are caused by the use of different
materials, like glass, plastic, and metal.
-
The shadows on the door panels, which look like stripes, are due to reflections from the
interior lighting.
-
Enamel is made at very high temperatures. This can cause a slight colour variation. This
is completely normal and does not affect the device operation. The edges on thin trays
cannot be completely enamelled. As a result, these edges can be rough. This does not
affect the corrosion protection.
-
Always keep the device clean and immediately remove the dirt so that the appliance does
not accumulate lasting dirt residues.
ENGLISH
BOLERO HEXA C134500 INOX A
73
