Idiomas disponibles
Idiomas disponibles
8
Troubleshooting
If a malfunction cannot be eliminated with the
measures described here, contact Weidmüller
Service.
8.1 Fault table
Fault
Possible cause
Machine cannot be
Power supply is interrupted
switched on.
Fuses have blown
Increased waste
Cutting blades damaged or blunt
Length deviation
Feed rollers worn
Contact pressure too low
Motor blocked
Cable feed difficult to move
8.2 Wear parts
Product
Feed roller (single)
Cutting blades (set)
50
Recommended action
► Check the mains cable and the mains
connection.
► Replace the fuses.
► Replace the cutting blades.
► Replace the feed rollers.
► Increase the contact pressure.
► Make sure that the cable feed is not
blocked, e.g. by knotted wires or other
blockages.
Order No.
On request
9054740000
See chapter
8.4
8.3
8.6
8.5
2819930000/02/06.2022
