Kenmore ELITE 596.76522500 Guía De Uso Y Cuidado página 10

Installation
Pullout Freezer Drawer
Cselect models)
To prevent accidental child entrapment or
suffocation risk, do not remove the divider in the top
freezer basket.
To avoid electrical shock which can cause severe
personal injury or death, disconnect power to
refrigerator before removing doors. After replacing
doors, connect power.
To Install:
1. Pull both rails out to
full extension.
2. While supporting
door front, hook
supports into slots
located on inside of
each slide.
Note
• All four drawer bracket supports must be in the
proper slots for the drawer to function properly.
To avoid possible injury, product, or property
damage, you will need two people to perform the
following instructions.
To Remove:
1. Pull drawer open to full
extension.
.
Tilt the lower basket
forward and lift to remove.
On each white drawer
bracket is a basket cradle
with two snap
attachments. To release
each cradle, unlatch the
snaps by pushing them
inward, away from the
side bracket. Lift the
cradles off of the rails.
4. Remove Phillips screw
from each of the drawer
slides (select models).
5. Lift top of drawer front
to unhook the drawer
from the slides. Lift
door front out to
remove.
3. Lower door front into final position.
4. Replace and tighten Phillips screws that were
removed from the drawer slides (select models).
5. Place the basket cradles back onto the drawer
slides. Align basket cradle snaps with the slots on
the drawer brackets and press each cradle
towards the bracket until it clicks.
Basket cradle
snap attachments
6. Tilt the lower basket front down and set it down
into the basket cradles.
10