Idiomas disponibles
Idiomas disponibles
16
Removing and Disassembling the Spa Light
7.
Using a 7/16" open-end or adjustable
wrench and a #3 Phillips screwdriver,
loosen the bolt tensioning the Wire
Clamp.
Note: Carefully remove the Clamp
Hardware. The wire clamp will
release a small amount of tension
when the nut reaches the end of bolt.
8.
Discard the Wire Clamp and Wire Clamp
Hardware.
9.
Lift the Light Housing away from the
Lens and Face Ring. Place the Light
Housing aside.
10.
Lift the Lens away from the Face Ring
and set it aside.
11.
Remove the Gasket from the Lens.
12.
Discard the Gasket.
Note: A NEW LENS GASKET
AND WIRE CLAMP MUST BE
USED EACH TIME THE LIGHT IS
REASSEMBLED.
Refer to 12V Spa Light Replacement
Parts on page 20 or 120V Spa Light
Replacement Parts on page 21 for
part numbers.
13.
To reassemble the light, continue to
Reassembling the Spa Light on the next
page.
INTELLIBRITE
Architectural Series Pool/Spa Light Installation and User's Guide
®
(cont.)
Pilot
Screw
Face
Ring
Wire
Clamp
Lens
Light
Housing
Lens
Gasket/
O-ring
