HOLZMANN MASCHINEN MTY 8-70 Manual De Instrucciones página 27

13.2 Handling
13.2.1 Switch the machine on and off
13.2.2 Grinding process
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or
death.
 Always disconnect the machine from the power supply before maintenance or
repair work and secure it against unintentional reconnection.
14.1 Cleaning
Regular cleaning guarantees the long service life of your machine and is a prerequisite for its safe
operation.
Incorrect cleaning products can attack the finish of the machine. Do not use any
solvents, nitro thinners or other cleaning products that could damage the machine's
finish.
Observe the specifications and instructions of the cleaning agent manufacturer.
Remove chips and dirt particles from the machine after each use with a proper tool.
•
• Prepare the surfaces and lubricate the bare machine parts with an acid-free lubricating oil
(e.g. WD40 rust inhibitor).
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Switch on
Press the switch-on button (I) of the switch unit.
•
Switch off
Press the switch-off button (0) of the switch unit.
•
WAR N I N G
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
Step 1:
•
Grind the first saw tooth by pushing the slip
block of the saw blade holder backwards
and forwards
Step 2:
•
Push back saw blade, rotate further to
second saw tooth
NOTE:
Pay attention to the position of the stop
pin!
Repeat steps until all saw teeth are grinded
•
NOTE: Check all settings and locks again
before grinding.
N O TE
27
MTY 8-70