HOLZMANN MASCHINEN MTY 8-70 Manual De Instrucciones página 26

13.1.1 Assemble the circular saw blade
13.1.2 Settings
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
1. Loosen the locking screw (1) and move the saw blade holder
back by turning the handwheel so that the circular saw blade
to be sharpened can be mounted
2. Fit the adapter disc (2) matching to the circular saw blade bore
3. Put on the circular saw blade (3)
4. Put on the pressure disc (4)
5. Fix with the clamping screw
NOTE:
Tighten the clamping screw of the saw blade holder so that
the saw blade may be turned without taking too much power.
•
•
Attach the saw tooth on the grinding disc and
adjust the grinding angle exactly.
Adjustment possibilities by means of:
Loosen the respective lock, set the exact angle
and tighten the lock again.
Adjust the tooth distance and chip removal:
NOTE:
Loosen the locking screw (2) and position the
rotating saw blade holder with the hand wheel
(1) so that the travel (3) of the sliding block
allows correct grinding of the saw tooth, then
tighten the locking screw again.
For large saw blade diameters, loosen the
locking lever (5), turn the saw blade holder (4)
by 180° and tighten the locking lever again.
Rotation table
•
• Rotatable saw blade holder
• Angle adjustment of the grinding
aggregate
Loosen the screw (1) on the bottom of the
•
lug (3)
Set the saw tooth on the grinding disc (6)
•
Adjust the grinding angle exactly
Place the stop pin (2) in a suitable position
•
in the space between the saw teeth.
Grind the first saw tooth
•
• Set the stop pin (2) to the saw tooth and fix
it again with the screw on the bottom of
the lug
• Adjust the support lug (4) to fit
Adjust the height by loosening screw (5),
•
adjusting the height and tightening the
screw again
OPERATION
26
MTY 8-70