Idiomas disponibles
Idiomas disponibles
ENGLISH
48
Spring washer Ф6
49
Tension bracket
Tools and hardware
-
Spanner with Philips screwdriver S13-S14-S15 (x1). Fig. 2
-
Spanner S10-S13-S17-S19 (x1). Fig. 3
-
Allen key S6 (x1) Fig. 4
-
Allen key S5 (x1) Fig. 5
-
(20) Axle (x2). Fig. 6
-
(23) Wave washer ø26xø16x0.3 (x2). Fig. 6
-
(25) D-shaped washer ø28xø16x5 (x2). Fig. 7
-
(26) Washer ø10xø25x2.0 (x2). Fig. 8
-
(27) Spring washer ø19.5xø11.5x3 (x2). Fig. 9
-
(28) Bolt M10x20 (x2). Fig. 10
-
(29) Carriage bolt M8×40 (x4). Fig. 11
-
(30) Curve washer ø20xø8x1.5 (x4). Fig. 11
-
(31) Cap nut M8 (x4). Fig. 11
2. BEFORE USE
-
This device is packaged in a way as to protect it during transport. Take the device out
of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the device when
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
-
Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the Official Cecotec Technical Support Service
immediately.
3. PRODUCT ASSEMBLY
Step 1: Front and rear stabilisers installation
1. Remove two hex bolts M8x16 (15) and two flat washers Ф20xФ8x1.5 (38) from the front
stabiliser (7). Unscrew the bolts using the Allen key S6 provided.
2. Attach the front stabiliser (7) onto the main frame (1) with the two hex bolts M8x16 (15)
and two flat washers Ф20xФ8x1.5 (38) previously removed. Tighten the bolts using the
Allen key S6 provided.
60
DRUMFIT CROSSFIT 3000 EOLO
8
97
End cap Ф38
4
2
