Idiomas disponibles
Idiomas disponibles
OBJ_BUCH-0000000419-001.book Page 9 Thursday, November 19, 2020 12:08 PM
Tool Specifications
Heating wire cutting
machine
Article number
Power supply
Frequency
Power input
without load (wire cold)
with load (wire hot)
Cutting length
Cutting depth
Cutting
Wire length
Diameter of wire
Weight
Class of protection
Product Features
1 Locking knobs
2 Depth limiter
3 Cutting bar
4 On/Off button
5 Clamping lever
6 Supporting rail, left
7 Supporting rail, right
8 Insulation-panel support
9 Wing handles
10 Legs
11 Tension spring
12 Guardrail-fastener
13 Standalone support leg with brace
14 Nut
15 Bolt
Not all of the accessories illustrated or described
are included as standard delivery.
The device is intended for thermal cutting of polysty-
SSG 305
rene insulation panels.
For damage caused by usage other than intended, the
0701 127 2
user is responsible.
230 V/AC
50 Hz
18.5 W
Initial Operation (see figure A)
173 W
Pull the device out of the packaging using the recessed
1270 mm
grip and not by the crossbar/legs.
305 mm
Remove the protective pad and place down the device
Thermal
upside down.
183 cm
Slightly loosen the wing handles 9, pivot out the legs
0.65 mm
10 and then tighten the wing handles again.
11.9 kg
Turn the device around and place it down on the legs
II
10.
Slightly loosen the locking knobs 1. Fold out the cutting
bar 3 and retighten the locking knobs.
Loosen clamping lever 5, position the supporting rail,
left 6 and then tighten the clamping lever again. Pivot
the supporting rail 7 down. Set the insulation-panel
support 8 to horizontal position.
Connect the power cord and start the device with the
On/Off button 4.
Replacing the Cutting Wire
Attach a fitting cutting wire via the eyelet to the upper
and bottom tension spring 11. Guide the cutting wire
around the two wire-guide rollers.
Place the polystyrene insulation panel on the support-
ing rail 6.
Straight cut: Pull the cutting bar 3 out, slide the insu-
lation panel into position and perform the cut.
Bevel cut: Loosen locking knobs 1 at the top and bot-
tom, and pivot the cutting bar 3 to the desired bevel
angle. Tighten the locking knobs 1 again and perform
the bevel cut.
Mitre cut: Loosen clamping lever 5 and adjust the
desired mitre angle. Retighten the clamping lever and
perform the cut.
Intended Use
(see figure B)
Cutting Options
9
