cecotec DRUMFIT WAYHOME 1000 RUNNER SPRINT Manual De Instrucciones página 63

Lubricating the walking belt
Correctly greasing the mechanisms that make up the treadmill will not only ensure a better
functioning of the treadmill but will also extend its lifespan. After the first 25 hours of use (or
2-3 months) apply a little lubricant and then repeat the operation every 50 hours of use (or
5-8 months).
How to check the lubrication status of the walking belt
Lift one side of the belt and touch the surface of the board. If the surface is slippery to the
-
touch, no further lubrication is required.
If the surface is dry to the touch, apply a small amount of lubricant.
-
How to apply the lubricant
Lift one of the sides of the belt.
-
Apply a little lubricant under the surface of the board as shown in figure 13. Make sure that
-
the lubricant reaches the centre of the platform.
Run the treadmill at low speed for 3-5 minutes to distribute the lubricant evenly.
-
ATTENTION: do not over-lubricate the platform. Wipe off any excess lubricant from under the
belt.
7. TROUBLESHOOTING
Problem
The treadmill does not
switch on
The belt is slippery
Possible causes
The machine is not plugged in.
The safety key is not properly
fitted.
The circuit breakers in the
house's electrical panel have
tripped.
The main switch of the
treadmill has tripped.
The belt is not sufficiently
tensioned.
DRUMFIT WAYHOME 1000 RUNNER SPRINT
Solution
Plug the power cord correctly
into a power outlet.
Put the safety key back on.
Turn the circuit breakers back
up or call an electrician to
replace the electrical panel.
Wait 5 minutes and try to start
the treadmill again.
Adjust the belt tension.
ENGLISH
63