Idiomas disponibles
Idiomas disponibles
ENGLISH
6. CLEANING AND MAINTENANCE
Cleaning
After each training session, make sure to clean the appliance and remove any remaining
-
sweat.
-
Clean the treadmill with a cotton cloth and a mild cleaning product. Do not use abrasives
or solvents. Be careful not to allow too much moisture to enter the display, as this could
damage the machine and create a risk of electric shock.
Please keep the treadmill, especially the control panel, away from direct sunlight to
-
prevent damage to the display.
Adjusting the walking belt
The belt is pre-adjusted to the platform at the factory, but, after prolonged use, it may
-
loosen and require readjustment. To adjust the belt, turn the treadmill on and let it run at
a speed of 6-8 km/h. Use the Allen key provided to turn the rear roller adjustment bolts to
centre the belt. If the belt moves to the left, turn the left adjustment bolt 90° clockwise. The
belt should begin to correct itself as shown in Figure 9.
If the belt moves to the right, turn the right adjustment bolt 90° clockwise, and the belt
-
should begin to correct itself. Continue turning the adjusting bolts until the belt is well
centred as shown in figure 10.
If the belt slips during use, turn off and unplug the treadmill. Using the Allen key provided,
-
turn the left and right adjustment bolts of the rear rollers 90° clockwise as shown in Figure
11. Then switch the treadmill back on and let it run at a speed of 6 km/h. Run over the belt
to determine if the belt is still slipping. Repeat this process until the belt stops slipping.
Storage
Store the treadmill in a closed, clean and dry place. Never leave or use it outdoors. Make sure
that the machine is switched off and the power cord is unplugged from the mains socket.
Folding/unfolding the treadmill
Before folding or unfolding the treadmill you must make sure that the belt is stationary,
-
and the treadmill is not connected to a power outlet.
Folding: lift the treadmill platform up towards the control panel until it fixes into place.
-
Unfolding: press the plastic part on the pneumatic cylinder with your foot as shown in
-
figure 12.
CAUTION: if the treadmill does not fold correctly, it is because of improper assembly. The
screws on the side rails should be better secured and the position of the control panel should
be adjusted.
62
DRUMFIT WAYHOME 1000 RUNNER SPRINT
