Idiomas disponibles
Idiomas disponibles
3. PRODUCT ASSEMBLY
Step 1
For this step, it is recommended that you are assisted by another person. One person
-
should hold the left/right handlebar support bars in place while the other tightens the
screws.
Use two screws S1, S2 and two S3 to fix both left/right handlebar support bars to the base
-
frame as shown in figure 2. The assembly is the same for both sides.
Step 2
Connect the control panel cable to the main cable coming from the right handlebar support
-
bar as shown in figure 3.
Insert both handlebar stems into the left/right support bars. Attach both handlebars to
-
the left/right support bars using two S2 and two S3 screws as shown in figure 3.
Please note:
While inserting the handlebar stems into the left/right support bars, make sure that the cables
inside the right support bar are correctly connected and be careful not to crush them.
4. OPERATION
Fig. 4 key:
1. Pulse indicator: displays your current heart rate in beats per minute (bpm). To activate,
grasp the touch sensors to measure your pulse during training. The display will show your
beating after 2-5 seconds. For the most accurate measurement, grasp the sensors with
both hands.
2. Speed indicator: it shows the current speed from the lowest, 1 km/h, to the highest speed,
10 km/h.
3. Time indicator: it shows the elapsed training time in minutes and seconds. The time starts
counting from 0:00 to 99:59 in 1 second increments.
4. Distance indicator: it shows the cumulative distance travelled during training.
5. Calorie indicator: it shows the total number of calories burned during training. (These data
are indicative for comparing different training sessions and should not be used for medical
treatment).
6. Programmes: press this button to select the pre-set training programme mode (P01-P12).
7. Start: press this button to start training.
8. Stop: press this button to stop training.
9. Decrease speed:
Press the decrease speed button in the manual mode to lower the desired training time or
-
distance settings.
Press the decrease speed button in the pre-set training programme mode (P01-P12) to
-
lower the desired training time settings.
DRUMFIT WAYHOME 1000 RUNNER SPRINT
ENGLISH
59
