Idiomas disponibles
Idiomas disponibles
ENGLISH
Dishes and cutlery
Incorrect programme
are not clean
Incorrect basket loading
1. Very hard water
2. Low inlet
temperature
3. Dishwasher
There are stains
overloading
and layers of dirt
4. Inadequate charging.
on glasses and
5. Old or wet detergent
cutlery
powder
6. Empty rinse aid
dispenser
7. Incorrect detergent
dosage
Cloudy glasses
Combination of soft
water and too much
detergent
There is a yellow-
Tea or coffee stains
brown layer on
internal surfaces
Iron deposits
in water can cause a
layer to form
White layer on the
Hard
inner surface
84
Bolero Aguazero 6500 C/ Inox C/ Dark C
Select a more powerful programme.
Make sure that the detergent dispenser and
spray arms are not blocked by large dishes.
To remove stains from glassware:
1. Remove all metal utensils from the
dishwasher.
2. Do not add detergent.
3. Choose the longest cycle.
4. Start the dishwasher and let it run for 18 to
22 minutes. The main wash should then be
carried out.
5. Open the door to pour 2 cups of white
vinegar into the bottom of the dishwasher.
6. Close the door and let the dishwasher finish
the cycle. If vinegar does not work: repeat the
above procedure but use 1/4 cup (60 ml) citric
acid instead of vinegar.
Use less detergent if you have soft water
and select a shorter cycle to wash the items
made of glass.
Use a solution of 1/2 cup bleach and 3 cups
of warm water to remove stains by hand.
WARNING
You have to wait 20 minutes after a cycle to
let the heating elements cool down before
cleaning the inside, otherwise it will burn.
You should call a water softening company
to fit a special filter.
To clean the interior, use a soft and damp
cloth with detergent for dishwasher and
use rubber gloves. Never use any cleaner
other than dishwasher detergent, otherwise
foaming may occur.
The detergent
dispenser lid
Detergent residues
cannot be closed
clog the lip seal
properly
There is still
The dishes block the
detergent in the
detergent dispenser
dispenser
There is steam
This phenomenon is
normal
There are black or
Aluminium items have
grey marks on the
brushed against the
tableware
tableware
There is standing
This is normal
water in the
bottom of the
dishwasher
Dispenser overfilling or
rinse aid spillage
The dishwasher
has a leak
Dishwasher is not level
In case the table above does not solve your problem, please contact the official Cecotec
Technical Support Service.
ENGLISH
Clean the detergent from the lip seal.
Load the dishes again correctly.
During drying and draining of the water,
some steam escapes from the ventilation
grille next to the door locking system.
Use a mild abrasive cleaner to remove these
marks.
A small amount of clean water around the
outlet at the bottom of the dishwasher keeps
the seal lubricated.
Be careful not to overfill the rinse aid
dispenser.
Spilled rinse aid could cause excessive
foaming and lead to
overflow. Wipe up any spilled rinse aid with a
damp cloth.
Make sure that the dishwasher is level.
85
Bolero Aguazero 6500 C/ Inox C/ Dark C
