Melchioni Family MF 9201L Manual De Instrucciones página 14

Choosing the installation point
Bracket installation
Shaft selection
The 12.5 cm shaft (2) is provided with a hemispherical head, which must be inserted into the bracket (1). If
it is necessary to use the 25 cm shaft (3), the hemispherical head must be extracted from the 12.5 cm shaft,
by unscrewing the yellow/green earth cable and sliding it along the shaft until it is completely extracted. It
will then have to be inserted into the 25 cm mast, at the end of which the transverse pin must be inserted,
also extracted from the 12.5 cm mast, then pushed at the end until it locks; the ground wire will then need
to be screwed back to the new shaft.
Blade assembly
screws in the upper part and two screws in the lower part. At the end of the assembly, all the holes must
contain a screw, the blades must have the same inclination and the center of the blade plane must consist
of an uninterrupted cylindrical band.
The fan must be installed near a permanent electrical
supply: in the case of installation near a central ceiling light
(typically in place of a chandelier), the mains voltage must
NOT be interrupted by a switch which, therefore, must
remain permanently in the closed position. In this way the
appliance will always be able to receive commands from
the remote control.
Pay attention that the minimum height of the blade
rotation plane is not less than 2.30 meters from the floor
and that the lateral space is not less than 50 cm.
To install the bracket (1) on wooden panels or false ceilings, use self-
tapping screws. Also check that the surface has the necessary
compactness to avoid tearing.
1 = wood screws
2 = Panel
To install the bracket (1) on inert materials (masonry, bricks, stone), use
expansion plugs with a minimum hole diameter of 6 mm. Also check that
the surface has the necessary compactness to avoid tearing.
1 = Expansion dowels
Use the provided screws (14), with washer (15), to secure the blades in
the appropriate holes along the perimeter of the motor. Pay attention to
install the blades in the direction indicated in the figure, i.e. leaving the
bushing for the shaft facing upwards and the writing "THIS SIDE UP" on
the blades also facing upwards. The holes are equidistant, so it is possible
to start assembly from any hole; each blade must be fixed with two