Thermador Professional PCG30 Manual De Instalación página 12

Product Rating
Label/Serial Tag
So
Threading compounds must be
go resistant to Propane Gas
1/2" NPT
f
3" Min.
Power
Cord or
2 Conduit
3-Prong grounding type receptacle
connected to a properly grounded and
polarized electrical supply rated at 120VAC,
10 Amps, (or 15A*) Single Phase, 60 HZ.
Co
Fr .
ti ~ 3/4" flex line
ace} —_. Gas flow
A manual valve must be installed
external to the appliance, in an acces-
sible location from the front, for the
purpose of shutting off the gas supply.
All Installer supplied parts must conform to Local Codes.
Figure 9: Bottom of Unit
*145 Amp 120 VAC electrical supply is required for 36" and 48" models with an electric griddle.
Step 3: Unpacking, Moving,
Placing and Anchoring the
Cooktop
A
Important
* Verify that the appliance is correct for the type of gas
being provided. Refer to Step 4 before proceeding with
the installation.
CAUTION
Proper equipment and adequate manpower
must be used in moving the appliance to avoid
damage and/or personal injury. The unit is
heavy and should be handled accordingly.
* Attach the backguard before sliding the appliance into
the final installed position. See Step 6.
* Remove the outer carton and packing material from the
shipping base. Ensure that you have all cooktop
components before proceeding.
* Remove the top grate castings and burner caps to
reduce cooktop's weight.
English 10
NOTE:
Leave adhesive-backed foam layer over brushed-metal
surfaces, to protect finish from scratches, until the cooktop
is installed in its final position.
* — Lift and place the cooktop in the opening. Be careful
not to pinch the power cord or gas inlet. Care should be
used not to scratch the griddle cooking plate.
* Make sure that the power cord is free and hanging
loose.
* The cooktop must be level for proper performance.
* Replace the cooking grates and burner caps. Ensure
that the burner caps are correctly seated on the burner
bases.
Griddle Tilt Adjustment (not all models)
Check the griddle adjustment by pouring two tablespoons
of water on the back of the griddle plate. The water should
slowly roll into the grease tray. If not, adjust the two screws
under the back of the plate. Start with one half turn counter-
clockwise (CCW) of the screws. Further adjustment should
be made by one-quarter turn until water slowly flows into
the grease tray.