Idiomas disponibles
Idiomas disponibles
ENG
A N O R D I C B R A N D
The ventilation pipe must not be distorted or be bent over 45°.
Cloth window seal
Alternatively, you can install the cloth seal:
1. Mark the middle "M" of the unfolded cloth seal before installing, to easier find the middle later.
Illustrations showing different window types. With suggested "A" and "B" markings. And suggested opening marked
with "S".
2. Mark the middle on the window's edge with "A" and "B" for example, or your choice of marks. The marks ("A" and
"B") must be placed exactly in opposite positions of each other.
Suggested placement of tape.
3. Place the hook-and-loop fastener tape on the edge of the window (usually 1 cm wide), where the window handles
are attached.
4. Now fasten the seal to the hook-and-loop fastener. First side "A", then side "B". Begin in the middle and work all the
way to the up and down or left and right depending on window type.
6. When closing the window take care that the seal does not get stuck on the window's edge.
7. Open the zip preferably at the position marked with "S" and attach the exhaust hose.
Important notice
The length of the ventilation pipe must be 280-1500 mm, the length is based on the specifications of the product. Do
not use extension pipes or replace it with a different type of pipe, or this may cause a malfunction. Do not block the
ventilation outlet, otherwise it may cause overheating.
Maintenance and cleaning
Before cleaning and maintenance, turn the product off and unplug the power plug.
Clean with surface with a wet soft cloth. Don't use chemicals, such as benzene, alcohol, gasoline. The surface could
be damaged or the whole product could be damaged.
