Tabla de contenido
Idiomas disponibles
Idiomas disponibles
8.3
Grounding Methods
This charger must be properly grounded. Make sure the AC outlet you are
plugging it into is properly grounded per local codes and regulations. If it
is not, have one installed by a qualified service person. Do not remove or
bypass the grounding pin on the plug or receptacle.
9.
MOUNTING INSTRUCTIONS
This charger can be operated on a stable surface either upright or lying
down (brackets not installed). Rubber strips have been provided to help
prevent scratching and denting of the channels. If you would like to perma-
nently mount the charger, use the following instructions:
9.1
Slide all 4 brackets (Item 1) into the track on the back, from the right
side, as shown above. Make sure the set screws (Item 2) are unscrewed
enough so they do not scratch the surface of the housing.
9.2
Measure what you are mounting the charger to before deciding where to
locate the brackets (add an additional ¼ to ½ inch). Use the ruler on the
label (Item 3) to mount the brackets (Item 1) in the correct position (posi-
tion each bracket an equal distance from the center of the charger). Note
that the inches shown are for both bracket dimensions combined (mean-
ing the dimensions are doubled), this is for easier reference. Make sure
the ¼-28 set screws (Item 4) are unscrewed enough so the pointed end is
almost flush with the bracket. Mount the brackets (Item 1) by tightening all
8 set screws (Item 2) to 14 in/lb (1.6 n/m) of torque.
9.3
Lift the charger by its handle and set it against your mounting location,
tighten the set screws (Item 4) to 66 in/lb (7.5 n/m) of torque to secure the
brackets (Item 1) starting with the top two brackets first.
7
•
•
Tabla de contenido
Solución de problemas
