Idiomas disponibles
Idiomas disponibles
NOTE: all compressed air systems generate condensate that accumulates in
any drain point (e.g., tanks, filter, aftercoolers, dryers). This condensate contains
lubricating oil and/or substances which may be regulated and must be disposed of in
accordance with local, state, and federal laws and regulations.
1.
Set the auto/off lever to "off" and unplug unit.
2.
Pull the regulator knob out and turn counterclockwise to set the outlet pres-
sure to zero.
3.
Remove the air tool or accessory.
4.
Pull ring on safety valve allowing air to bleed from the tank until tank pressure
is approximately 20 psi. Release safety valve ring.
5.
Drain water from air tank by opening drain valve (counterclockwise) on bottom
of tank.
Risk of Bursting. Water will condense in the air tank. If not
drained, water will corrode and weaken the air tank causing a risk of air tank
rupture.
Risk of Property Damage. Drain water from air tank may contain oil
and rust which can cause stains.
6.
after the water has been drained, close the drain valve (clockwise). The air
compressor can now be stored.
NOTE: If drain valve is plugged, release all air pressure. The valve can then be
removed, cleaned, the reinstalled.
AIR FILTER - INSPECTION AND REPLACEMENT
Hot surfaces. Risk of burn. Compressor heads are exposed
when filter cover is removed. Allow compressor to cool prior to servicing.
Risk of Property Damage. Keep the air filter clean at all times. Do
not operate the air compressor with the air filter removed.
a dirty air filter will not allow the compressor pump to operate at full capacity.
before you use the compressor pump, check the air filter to be sure it is clean and
in place.
If it is dirty, replace it with a new filter.
1.
Remove the air filter cover.
2.
Remove the air filter from filter cover.
3.
Place new air filter into filter cover.
4.
Replace air filter cover and lock into place.
AIR COMPRESSOR PUMP INTAkE AND ExHAUST VALVES
once a year have a Trained Service Technician check the air compressor pump
intake and exhaust valves.
14- eNG
