Idiomas disponibles
Idiomas disponibles
REMOTE CONTROLLER
OPERATION
5 REMOTE CONTROLLER OPERATION
5.1. LIQUID CRYSTAL REMOTE CONTROL PC-ART
Liquid crystal display (LCD)
MODE
FAN SPEED
VENTI
LOUVER
Model: PC-ART
Fan speed indicator
Indicates the ventilation speed selected:
-
(High / Medium / Low)
Indicator of Total ventilator
Indicates if the total heat exchanger has been selected.
-
A/C
only air conditioning
-
VENTI
only ventilation
-
A/C + VENTI
if both are selected
Operation Mode Indicator
Indicates the operation mode selected:Fan/Cool/Heat/Dry/Auto
(Cool/Heat)
Run indicator (Red lamp)
RUN/STOP switch
MODE (Operation Mode Selection) switch
FAN SPEED (Fan Speed Selection) switch
Up & down panel operation switch
VENTI (ventilator operation) switch
LOUVER (deflector panel) switch
SELECT (Day/Schedule) switches
Increase and decreases the Day/Schedule for timer operation.
ON/OFF TIMER switch
Used to activate or deactivate the timer operation.
TIMER
RESET
SCHEDULE
OK
DAY
SELECT
OK switch
RESET (Filter Reset Switch)
After cleaning the air filter, press the "RESET" button. FILTER
indication will disappear and the next filter cleaning time is reset. It
also stops the run procedure.
TEMP (temperature setting) switches
T.RUN (test run indication)
Check (check indication)
These tests appear when TEST RUN or CHECK are being
performed.
ABNML (alarm) indicator
SET TEMP (set temperature) indicator
1234S indicator (setting schedule number)
Mon Tue ... Sun indicator (day of the week indicator).
Indicates that central station or CSNet control is operating.
Swing louver indicator
DEFROST indicator
SERVICE mode indicator.
Indicates the change to special operations
Time indicator.
Time indicator. (Indicates the programmed time).
To open the cover, pull in the
direction of the arrow.
NOTE:
- If the LOW fan speed is selected and the outdoor temperature is
higher than 21°C, the compressor is subjected to an excessive
load when operating in heating mode.
Therefore, the fan speed should be set to HIGH or MEDIUM to
avoid activating the safety devices.
- When the system is restarted after a shutdown of more than
approximately 3 months, the system should be checked by your
service provider.
- Turn off the main switch when the system is to be inoperative for
a long period of time. Otherwise the system consumes electricity
as the oil heater remains active even though the compressor is
stopped.
PMML0185 rev.1 - 03/2010
13
