Idiomas disponibles
Idiomas disponibles
DESCRIPTION
This appliance is intended for domestic purposes only, not for professional use. The description below
corresponds to image 1 on page 2.
1. Hose connection
2. Cord retractor
3. Vacuum cleaner handle
4. On/off switch
5. Rear wheels
6. Dust collector
7. Hose
8. Hose handle with air opening
BEFORE FIRST USE
1. Remove all packaging materials.
2. Insert the telescopic tube into the combination nozzle and insert the hose into the other end of the tube.
Press the button on the tube to make it longer or shorter.
3. Insert the other end of the hose into the hose connector on the vacuum cleaner until it clicks into place.
Check whether the dust collector is properly clicked into place on the vacuum cleaner.
VACUUM
1. Select the correct position of the combination nozzle. You can choose from the brush setting for hard
floors (parquet, laminate, etc...) or the setting for soft floors (carpet, carpet, etc...).
2. Pull the cord out of the vacuum cleaner up to the yellow marking and plug it into a wall socket.
3. Press the on/off button and start vacuuming.
NB:
•
You can reduce the suction power by temporarily opening the closable air opening. This prevents textiles
from being sucked into the hose.
•
You can lift the device by the handle.
•
To avoid damage, never extend the cord beyond the red marking.
ACCESSORIES
This vacuum cleaner has a 2-in-1 attachment supplied. Use this as a crevice tool to clean radiators,
cracks, window frames, holes and the like. Use it as a small brush to clean delicate or uneven surfaces,
furniture, blinds and the like.
EMPTYING THE DUST COLLECTOR
If the dust collector full indicator turns red, empty the dust container immediately.
1. Remove the hose by pressing the two side buttons on the connection piece.
2. Remove the dust collector by pushing the release button, see figure 2A on page 2.
3. Hold the Dust collector above a waste bag and let the bottom cover fall open by pressing the button, see
images 2B and 2C on page 2.
4. Remove any stuck debris by hand or a small brush.
5. Close the bottom cover until it clicks into place and place the dust collector back on the device until it
clicks into place.
NB:
It is possible that the indicator turns red while the dust collector is not yet full. Then check the nozzle, hose
and tube to see if they are clogged.
9. Release button
10. 2-in-1 Attachment
11. Telescopic tube
12. Combination nozzle
13. Exhaust filter
14. Dust collector release button
15. Dust collector full indicator
17
EN
