32
TROUBLESHOOTING
BEFORE
CALLING
FOR
SERVICE
(confinued)
Wrinkling
Excessive sudsing
Staining
Washer will not turn
ON
Wash cycle time is ion-
ger than usual
Musty or mildewy
odor
inwasher
Water leaks
i!i: i!: _i_!_!_!_i_i_i_i_i_i_i_i_i_!!_!_!!_!i_i_i_!!_ii!_i!_J_iii
_i__!iB'i _i!i!i_i_!_!_!ii_i!i_i!ii_ii_iiiiiiiiiiiii_ii_!_!i_i!i_i!i_i!iiiiiiiiii_!i_
_! i, !!!i!!i_ii!i!i!i!i!i!i!i!i!iiiili!iiiili!iiiiiii_i_ii
iiiiiiiiiiii_i_i_i_i_iiiii_!i_i_i_ii_ii_ii_ii_ii_ii_ii_ii_ii_ii
_i_ iil_ _ !!_!i
_!_i!!i_i_!i_!i_!ii!ii!ii!ii!ii!ii!ii!i!!i
¸ _ __________________
Washer not unloaded promptly,
i AIways remove
items from the washer
as soon as the
cycle is complete.
Washer overloaded.
The washer can be fully loaded, but the tub should not be
j tightly
packed with items. The lid of the washer should
j close easily.
Hot and cold water inlet hoses are Hot water rinse can set wrinkles
in garments.
Check the
reversed.
'inlet hose connections.
Too much
detergent
or incorrect JHE detergents
are formulated
specifically
for High-Effi-
detergent,
j ciency washers and contain suds-reducing
agents.
Only
l use detergent with the High-Efficiency
(HE) logo. For de-
tergent quantities
refer to the How to Use section.
Bleach or softener
dispensed
too JDispenser compartment
is overfilled
causing
bleach or
soon.
softener
to dispense
immediately.
ALWAYS
measure
j bleach to prevent overfilling - one cup maximum.
j Dispenser drawer closed too quickly causing softener to
dispense immediately.
Bleach or softener
was added di-JAIways
use the dispensers
to ensure that laundry prod-
rectly to the wash load in the tub.
j ucts are properly dispensed
at the right time in the cycle.
Washer was not unloaded prompt-
Always remove items from the washer as soon as pos-
ly.
sible after the cycle is complete.
Clothes were not properly sorted.
JAIways wash dark colors separately from light colors and
whites to prevent discoloration.
Never wash heavily soiled items with lightly soiled items.
Power cord is not properly plugged
Make sure that the plug is plugged securely into a ground-
in.
led, 3-prong, 120-VAC, 60-Hz outlet.
House fuse is blown, circuit break-J Beset circuit
breaker or replace fuse. Do not increase
er has tripped,
or power
outage
fuse capacity. If the problem is a circuit overload,
have it
has occurred,
corrected by a qualified electrician.
NOTE: If the washer stopped during a cycle due to a loss of power, the washer will resume
the cycle where it stopped when the power is restored.
The washer
automatically
adjusts JThis is normal. The washer adjusts cycle time automati-
the wash time for the amount of j cally to provide optimal results for the selected cycle. The
laundry, water pressure
and other
time remaining shown in the display is only an estimate.
Actual time may vary.
Use only High-Efficiency
{HE) detergent
in accordance
with the manufacturer's
instructions.
Run the Tub Clean cycle regularly.
operating conditions.
incorrect
or too much
detergent
has been used.
inside of tub was not cleaned prop-
erly.
Oversudsing
of detergent.
j OversudsJng may create leaks, and may be caused by the
type and amount of detergent
used. High-Efficiency
de-
tergent
is the only detergent
recommended.
Make sure
j that detergent
and any additives are put into the correct
dispenser
compartments.
The normal amount of deter-
jgent to use is 1/4 to 1/2 of the maximum
amount recom-
j mended
by the detergent
manufacturer.
Always reduce
Jthe amount
of detergent
if the load is small or lightly
j soiled, or if your water is very soft. Never use more than
j the maximum
amount recommended
by the detergent
manufacturer.