Idiomas disponibles
Idiomas disponibles
Product Description
Component Groups and Functioning Elements
See Fig. 1 (on inside cover)
1 Front cover
2 Power cable
3 Water connection
4 Trimmer table
5 Spray tube
6 Blind plug
The other units are covered in the full set of operating instructions available on the internet.
Standard Delivery
1 MTplus
1 Water hose
1 Drain hose
1 Tool set
1 Hardware set
1 Marathon trimmer disc, only on Nr. 1803-x500
1 Quick Start Guide
Installation
Unpacking
⇒ Check to ensure all delivery parts are complete (compare "Standard Delivery").
Setting Up
⇒ Place the unit on a level and stable base.
⇒ Place appliance with easy access to the mains plug socket.
Wet Trimming
⇒ Connect water hose (7) to water connection (3).
⇒ Connect the water hose to a water supply with a shutoff tap.
⇒ Open the shutoff tap and check for leaks.
⇒ Twist drain hose (8) onto connection fitting (10).
⇒ Fix with a hose clamp (9).
⇒ Place drain water hose with downward slope.
⇒ Unroll the power cable (2) and insert the plug into the socket.
Dry Trimming
⇒ Open the front cover (1).
⇒ Remove the spray tube (5).
⇒ Close the opening with the blind plug (6) from the hardware set.
⇒ Close the front cover (1).
⇒ Push the suction tube onto the connection fitting (10).
⇒ Unroll the power cable (2) and either insert the plug into the automatic switch-on socket of the suction
unit or into the mains power socket.
Please observe the maximum connection load for the automatic start and suction. If necessary,
connect the suction unit and trimmer to separate power supplies.
7 Water hose
8 Drainhose
9 Hose clamp
10 Connection fitting
11 Water valve
- 3 -
EN
