Idiomas disponibles
Idiomas disponibles
Pull Transformer
Cord out
[]
Open
Right
Door,
then
pull the
Trans-
former Cord out through the gap between
the Tank Tray and the Middle Cart Panel.
[]
Plug Transformer
Cord
into a properly
grounded outlet.
[]
Close the Right Door.
Note: In case of light bulb failure replace with
12 volt 10W bulb only to avoid damaging
the
electrical
transformer.
Install
Ignitor
Battery
[] Unscrew
Ignitor Cap from
Control
Panel.
[] Place supplied AA battery
into the Ignitor
Slot with positive pole facing
you.
[] Position the Cap and Spring over the AA
battery and tighten onto Control
Panel.
":i
Ignitor Slot
' ".i
AA
Battery
_j
Ignitor Cap ............ _ \\
Spring
- AA Battery may be installed backwards.
Electric wires may be loose. Remove the AA
Battery and inspect the Ignitor Junction Box found
behind the Control Panel and reconnect any loose
wires.
3!16" _park Gap
,Gas Collector
/' Box
i
i
'Spark Electrode Tip
Spark Receiver
Infrared
Burner
and
Rotisserie
Burner
Electrode
Check
[]
Push and turn Infrared Burner Control Knob &
Rotisserie Burner Control Knob to _. Look for
spark between electrode tip and spark receiver
tip.
[]
If you don't see a spark from Infrared Burner
Electrode or Rotisserie Burner Electrode, adjust
gap between electrode
tip and spark receiver
tip to 3/16 inch.
Install
Cooking
Components
[]
Place the Heat Diffusers above the Burners.
The Heat Diffusers can only be placed correctly in
one direction, with the underside peg towards the
back ledge.
[]
Place the Cooking Grids on the ledge above the
Heat Diffusers.
[]
Place the Secondary Cooking Rack into the slots
on Grill Bowl Side Panels.
Secondary Cooking Rack
_
Cooking Grids
_
_
Heat Diffusers_;_
_
Main
Burner
Electrode
Check
With
the assistance
of another
person,
perform
this
Electrode
Check
before
proceeding.
This test will ensure that the Spark Electrode Tips
are properly positioned so your grill lights easily
and properly.
[]
Be sure all Control Knobs are set to "OFF" and
open the Grill Lid.
[]
Have your assistant stand behind to the right of
the grill and look toward the front of the grill bowl.
Never put your face inside the Grill Head.
[]
Push and turn Burner Control Knob to _: and
you will hear a "clicking" sound as the burner
is being ignited. Your assistant should
see a
blue spark within each Gas Collector
Box. If
a spark
is present
the
Electrode
Tips are
properly
positioned.
[]
If no spark is seen, the Spark Gap needs to be
adjusted
as follows:
• If the gap between the Spark Electrode Tip
and
Receiver
is more than
3/16"
use an
adjustable
wrench
to gently
squeeze
the
Gas Collector
Box to narrow gap.
• Recheck the Electrode again, if no "clicking"
sound is heard:
When you have finished
assembling your grill
be sure that all screws are tightened
for safe
operation
of your grill.
Failure to read and follow
the Use and Care
Instructions could result in a fire orexplosion that
could causeserious bodily injury, death or prop-
erty damage.
10
