Idiomas disponibles
Idiomas disponibles
11. Install the 2 screws, the 6 washers and the 2 nuts on
the left side of the handle.
12. Install the 2 screws, the 6 washers and the 2 nuts on
the right side of the handle.
13. Connect the cables to the control panel and the blast
motor.
To replace the front rubber seals
1. Operate the product rearward up a ramp.
2. Lift the front part of the product and tilt the product
rearward.
3. Use a piece of wood to lock the product.
2107 - 001 - 27.07.2023
4. Loosen the 6 nuts and then loosen the 3 bolts.
5. Remove the front rubber seals.
6. Install the new front rubber seals (A) with the steel
strips (B) between the front rubber seals. The angle
strip (C) is part of the body and can not come off.
B
C
B
7. Install the 3 bolts, tighten the inner nuts first and then
the outer nuts.
8. Remove the piece of wood and put the front wheel
on the surface.
B
A
A
A
25
