Dometic CAM35 Instrucciones De Montaje página 15

CAM35
• To prevent damage to the cables when laying them, ensure that they are far
enough away from hot or moving vehicle components (exhaust pipes, drive
shafts, light systems, fans, heaters, etc.). Use corrugated piping or other protec-
tive materials to protect against mechanical wear.
• Screw on the plug connections for the connecting cables to protect them against
water penetration (fig. d, page 7).
• When laying the cables, make sure:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp-edged ducts without protection.
• Attach the cables securely in the vehicles to prevent tripping hazards. This can be
performed by using cable binders, insulating tape or gluing in place with adhe-
sives.
➤ Lay the system cable.
6.3 Establishing the electrical connection for the camera
I
NOTE
• Lay the camera cable so that, should you need to remove the cam-
era, you can access the plug connection between the camera and
the extension cable easily. This greatly facilitates the disassembly.
• To minimise corrosion in the plug, apply a small amount of grease,
such as pin grease, in one of the plugs.
➤ Guide the connector of the brake light through the console.
➤ Re-attach the plug (fig. a 1, page 6) of the brake light onto the brake light.
➤ Connect the camera as shown in fig. b, page 7 to fig. d, page 7.
EN
Fitting the camera
15